Jump to content

Search the Community

Showing results for tags 'transmission & running gear'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Project Plough/Weasel Restoration (T15, T24, M29 & M29C)
    • Headquarters
    • Buy, Sell, Trade


There are no results to display.

There are no results to display.


  • Community Calendar


  • Weasel Resources (Vendors, How-To's & More)

Product Groups

  • Merchandise


Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start



About Me

Vehicles & Projects


Found 6 results

  1. Hi, I'm sure that this has been addressed in some form or fashion in the past but I can't seem to locate it. Does anyone have a reference for modern bearing, race and seal numbers for the suspension on the weasels? Ive found the bogie seals with skf 12391. But can't find the bearings or races/cups. Also looking for the same info on the idler and drive bearings. And u joints for the drive shafts for that matter. Any help would be appreciated! Thank you!
  2. Hello! I am new to the forum. @OZM29C I'm impressed with your work - it looks great! I have a smaller scale project where I am in process of rebuilding just the weasel final drive. Everything looks pretty good, with exception of the bevel ring gear. The corners of the outside corners of the teeth have been damaged and a bit of metal shavings are in the oil. It appears that the pinion end play is off. I Have found a NOS replacement pinion and ring gear that should fit, though not excited about the prospects of replacing it after reviewing the tech manual. The bearing surfaces of the teeth
  3. I resently removed the motor from my weasel and discovered that there is a switch by the output shaft. The wires were cut and not anywhere to be found i was wandering if the switch could be a neutral safety switch. Larry
  4. Hi! im a new member to this forum, and almost a new owner of a Studebaker Weasel m29c. The one I bought is in quite rough condition tho, only 3 leaf springs ass. and diff are still present. Also most of the bottom has rusted away. But im young, and optimistic, thus, I need pretty all parts that I can find. So send me everything that you can find! I am located in The Netherlands, and I don't really have the contacts to look for parts. So im hoping this will turn something up. of course shipping will be painfull, but still, let me know if you know something! I prefer parts from Europe, but, begg
  5. When reconditioning your rear hub assembly, you will need these. First off the outer hub. The most popular seal to use is the Caterpillar seal but there is also an alternative is a National oil seal 365008 . Please be aware that the width of this seal is only 6.35mm (1/4" inch). https://autoplicity.com/2379409-national-oil-seal Federal Mogul National Oil Seals - Hub Seal Alternative.docx
  • Create New...