Jump to content

Track tensioning


Larry Mass
 Share

Recommended Posts

Hi to all i hope everyone is safe and well. I got 1 track on my t15 after putting belting on the outside and inside of the track i also re rubbered the drive wheels idler wheels and return wheels. I don't have a track tensioning guage my question is how do i tell if the tension on the track is correct.  I took the shims out of the stop bracket and the track still looks to tight to me so i am wandering if there is a way to tell if its to tight.

Thanks

Larry 

1619367192404-538337688.jpg

Link to comment
Share on other sites

Posted (edited)

Larry 

I just use a porta power to push on the rear axle pivot to adjust your spring adjusters to the tension desired. Make sure you don't mix up the spacer blocks on the tensioners the thicker spacer goes closest to the spring end and should also have a flat 1/16 or so shim. Get the track where it feels tight and has some up and down play and that's about it no real science to it. I have attached a parts diagram showing the adjusters and shims. Hope this helps.

Dan

20210501_152643[1].jpg

Larry Mass Drawing.png

Edited by M29
  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...