Jump to content

Rebuilding seat back hold down latches.


Recommended Posts

The rod can be center drilled on the lathe in order to form a new peened end, or it can be drilled for a pin. We used a pin on this one. The rod will be about 1/8” shorter than it was before. All the internal parts, including the rod can be discarded and new ones installed. I used stainless rods on mine before. I found that 1/4” lock washers bent flat work perfectly for the washers. A cotter pin can be used, but may not clear the sides of the barrel. Here a piece of heavy wire was used. 

FBBFAB2A-A28B-4052-8D29-F2141E29C247.jpeg

Edited by Jesse Browning
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...