OZM29C Posted June 28, 2021 Share Posted June 28, 2021 I had to fabricate and fit a shift lever air deflector seal to my M29C. Unfortunately I did not have an OEM drawing to work from but I was given a drawing for the early T24 canvas shift lever. From there I drew and fabricated a metal (and felt) shift lever seal. A quick disclaimer. This shaft seal fitted my M29C but I can't guarantee it would fit other M29C's. Anyway drawings and happy snaps below. Shaft Seal for gear slectors.pdf Quote Link to comment Share on other sites More sharing options...
Patrick Tipton Posted June 29, 2021 Share Posted June 29, 2021 John - always learning something! I am assuming this goes on the inside...the engine side of the instrument panel....? I have never seen this part. Quote Link to comment Share on other sites More sharing options...
JamesD Posted July 2, 2021 Share Posted July 2, 2021 On 6/29/2021 at 9:13 AM, Patrick Tipton said: John - always learning something! I am assuming this goes on the inside...the engine side of the instrument panel....? I have never seen this part. Patrick this is a late production M29C part. Your T24 did not have this At some point a piece of canvas was used by the motor pool until the factory installed this part. Quote Link to comment Share on other sites More sharing options...
M29C3284 Posted July 10, 2021 Share Posted July 10, 2021 (edited) Here are a few pictures of the early canvas shift lever seal, installed from serial 1003. 954165: 954396: Edited July 10, 2021 by M29C3284 2 Quote Link to comment Share on other sites More sharing options...
F.Janssen Posted July 20, 2021 Share Posted July 20, 2021 These are pictures of my original: 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.